unixdev.net


Switch to SpeakEasy.net DSL

The Modular Manual Browser

Home Page
Manual: (FreeBSD-5.4-RELEASE)
Page:
Section:
Apropos / Subsearch:
optional field

DIGICTL(8)                BSD System Manager's Manual               DIGICTL(8)

NAME
     digictl -- control Digiboard devices

SYNOPSIS
     digictl -a disable | enable | query device ...
     digictl [-d debug] [-ir] ctrl-device ...

DESCRIPTION
     The digictl utility provides control of the Digiboard installed with the
     given ctrl-device name and provides control of individual digiboard
     devices.  A digiboard ctrl-device is usually of the form /dev/digiN.ctl
     where N is the card number and starts at ``0'' for the first attached
     card.  A digiboard device is usually of the form /dev/cua[il]DN.P or
     /dev/tty[il]DN.P where N is the card number and P is the port number.

     The following flags are recognized:

     -a disable | enable | query
                 Disable, enable or query the ALTPIN settings for the given
                 port(s).

                 When ALTPIN is enabled, the CD and DSR lines are logically
                 reversed.  This is useful when wiring serial ports to an 8
                 way RJ45 cable (full 10 way RJ45 cables are quite rare).

                 A single ALTPIN setting applies to both of the callout and
                 callin devices.

     -d debug    If the driver has been compiled with DEBUG defined, the fol-
                 lowing bits from the debug variable are used to enable diag-
                 nostics in the digiboard driver:

                 1 (INIT)      Diagnostics during card attach, detach and ini-
                               tialization.

                 2 (OPEN)      Diagnostics when opening a port.

                 4 (CLOSE)     Diagnostics when closing a port.

                 8 (SET)       Diagnostics when setting tty device flags.

                 16 (INT)      Diagnostics when processing card events.

                 32 (READ)     Reports return values from port reads.

                 64 (WRITE)    Reports return values from port writes.

                 128 (RX)      Reports receive queue flow control.

                 256 (TX)      Reports transmit queue flow control.

                 512 (IRQ)     Diagnostics during interrupts (enable these
                               with care).

                 1024 (MODEM)  Diagnostics when setting modem status flags.

                 2048 (RI)     Reports when a RING is received.

     -i          Display the card identification string and type ID.

     -r          Reinitialize the card.  For boards with external port mod-
                 ules, it is possible to add or remove modules and dynamically
                 reprobe the number of ports using this switch.  All ports on
                 the card must be closed in order to reinitialize the card.

                 It is preferable to reinitialize the card rather than reload
                 the entire digi module as reinitialization only affects the
                 specified board rather than affecting all attached boards.

BUGS
     It should be possible to reinitialize a board without closing all of the
     existing ports.

HISTORY
     The digictl utility first appeared in FreeBSD 5.0.

BSD                              June 20, 2001                             BSD