XIRC2PS_CS(4) Kernel Interfaces Manual XIRC2PS_CS(4)
xirc2ps_cs - Xircom CE2ps (and newer) device driver
insmod xirc2ps_cs.o [pc_debug=n] [full_duplex=n] [irq_list=i,j,...]
xirc2ps_cs is the low-level Card Services driver for the Xircom 16-bit
PCMCIA ethernet adapters. When this driver is attached to a card, it
allocates the next available ethernet device.
Selects the PCMCIA debugging level. This parameter is only
available if the module is compiled with debugging enabled. A
non-zero value enables debugging.
Selects the transceiver type, for some CE3B-100 cards that lack
the ability to autonegotiate. For such cards, a value of 1
selects 10baseT, and 4 selects 100baseT.
Selects full duplex mode. The default is 0 (half duplex).
Specifies the set of interrupts that may be allocated by this
Enables a hack to avoid lockups on some cards. Use this only
if you really have lockup problems with your card.
Please report to <xircom-bugsATisil.de>
This man page describes the standalone PCMCIA drivers provided by the
pcmcia-cs source, not the PCMCIA kernel driver support that is included
in the 2.4 (and later) linux kernel. While the kernel PCMCIA code has
the same functionality as the driver side of the standalone PCMCIA
package, there are some important differences. Therefore, some or all
of this documentation might not apply to the kernel drivers.
Werner Koch <werner.kochATguug.de>
1.5 1998/09/15 12:40:59 XIRC2PS_CS(4)