Switch to SpeakEasy.net DSL

The Modular Manual Browser

Home Page
Manual: (FreeBSD-5.4-RELEASE)
Apropos / Subsearch:
optional field

UTOPIA(4)                BSD Kernel Interfaces Manual                UTOPIA(4)

     utopia -- driver module for ATM PHY chips

     device utopia

     This module is used by all ATM drivers for cards that use PMC-Sierra
     S/Uni and IDT77105/IDT77155 chips to provide uniform functionality.  The
     module implements status monitoring in either interrupt or polling mode,
     media option handling and application access to chip registers.

     The driver implements several sysctls that are accessible under the
     hw.atm.<iface>. tree, where iface is the name of the ATM interface:

             When reading this sysctl an array of 8-bit unsigned integers is
             returned containing all accessible chip registers starting at
             register 0.  A register can be written by writing three 8-bit
             unsigned integers to the sysctl: the register number, the new
             value and a bit mask.  This changes all bits in the register for
             which the corresponding bit in the mask is one to the bit values
             from value.  Note that not all registers may be writeable.

             allows to put the interface in one of several loopback modes.
             Not all modes and all combinations of modes are supported on all
             chips.  The possible modes are:

             UTP_LOOP_NONE (0x00)
                     No loopback, normal operation.

             UTP_LOOP_TIME (0x01)
                     Timing source loopback.  When this is set the transmit-
                     ter's clock is derived from the receiver's clock.

             UTP_LOOP_DIAG (0x02)
                     Diagnostic loopback.  In this mode the receiver's input
                     is connected to the transmitter's output.  The receiver
                     gets back everything that is sent.  The transmitter oper-
                     ates normally.

             UTP_LOOP_LINE (0x04)
                     Serial line loopback.  This connects the line receiver to
                     the line transmitter.  The chip transmits all cells back
                     that it receives.  The receiver operates normally.

             UTP_LOOP_PARAL (0x08)
                     Parallel diagnostic loopback.  This feeds back all trans-
                     mitted cells into the receiver between the paral-
                     lel/serial converters.  The transmitter operates nor-

             UTP_LOOP_TWIST (0x10)
                     Twisted pair diagnostic loopback.  Connects the high
                     speed receive data to the high speed transmit data.  All
                     received data is sent back.  The receiver operates nor-

             UTP_LOOP_PATH (0x20)
                     Diagnostic path loopback.  This connects the receiver
                     input to the transmitter output just between the path
                     overhead processor and the byte mux.  The transmitter
                     operates normally.

             This is the detected type of the phy chip.  Currently the follow-
             ing chips are supported:

             UTP_TYPE_UNKNOWN (0)
                     The module could not determine the type of the PHY chip.

             UTP_TYPE_SUNI_LITE (1)
                     PMC-5346 (S/Uni-Lite)

             UTP_TYPE_SUNI_ULTRA (2)
                     PMC-5350 (S/Uni-Ultra)

             UTP_TYPE_SUNI_622 (3)
                     PMC-5355 (S/Uni-622)

             UTP_TYPE_IDT77105 (4)
                     IDT77105 (25.6MBit UTP interface)

             UTP_TYPE_IDT77155 (5)
                     IDT77155 (155MBit interface)

             This is a string describing the type of the PHY chip.

             Physical and some ATM layer statistics.  These are the statistics
             usually provided by the chip.  The data is a returned in the fol-
             lowing structure:

             struct utopia_stats1 {
                     uint32_t version;       /* version of this struct */
                     uint32_t fill;
                     uint64_t rx_sbip;       /* rx section BIP errors */
                     uint64_t rx_lbip;       /* rx line BIP errors */
                     uint64_t rx_lfebe;      /* rx line far end block errors */
                     uint64_t rx_pbip;       /* rx path BIP errors */
                     uint64_t rx_pfebe;      /* rx path far end block errors */
                     uint64_t rx_cells;      /* received cells */
                     uint64_t rx_corr;       /* correctable cell errors */
                     uint64_t rx_uncorr;     /* uncorrectable cell errors */
                     uint64_t rx_symerr;     /* symbol errors */
                     uint64_t tx_cells;      /* transmitted cells */

             The current version is 1.  The statistics are updated from the
             chip once a second.  On overflow the counters wrap to zero.  Note
             that not all counters are meaningful for all PHY chips.  The sta-
             tistics are cleared by writing an arbitrary new value (the value
             is ignored).

     The utopia module also interfaces with the ifmedia system.  The module
     reports the current state of the carrier and will issue a warning message
     when the carrier state changes.  While the physical media itself cannot
     be changed, several media options can:

     SDH     If the PHY is a Sonet/SDH chip this flag switches the interface
             into SDH mode.  If this option is not set (the default) the
             interface is in Sonet mode.

             If the PHY is a Sonet/SDH chip disable scrambling.  This may be
             useful for debugging purposes.

             Normally the interface emits idle cells when there are no other
             cells to transmit.  This changes the default cell type to unas-
             signed cells.  This may be needed for interworking with public

     en(4), fatm(4), hatm(4), patm(4), utopia(9)

     Harti Brandt <hartiATFreeBSD.org>

BSD                               May 8, 2003                              BSD