AHD(4) BSD Kernel Interfaces Manual AHD(4)
ahd -- Adaptec PCI/PCI-X Ultra320 SCSI host adapter driver
For one or more PCI/PCI-X cards:
To compile in debugging code:
options AHD_DEBUG_OPTS=<<bitmask of options>>
To configure one or more controllers to assume the target role:
options AHD_TMODE_ENABLE=<<bitmask of units>>
For one or more SCSI busses:
This driver provides access to the SCSI bus(es) connected to Adaptec
AIC79xx host adapter chips.
Driver features include support for narrow and wide busses, fast, ultra,
ultra2, ultra160, and ultra320 synchronous transfers, packetized trans-
fers, tagged queueing, 512 SCB's, and target mode.
The AHD_DEBUG_OPTS option is used to control which diagnostic messages
are printed to the console when AHD_DEBUG is enabled. Logically OR the
following bits together:
0x0001 Show miscellaneous information
0x0002 Show sense data
0x0004 Show Serial EEPROM contents
0x0008 Show bus termination settings
0x0010 Show host memory usage
0x0020 Show SCSI protocol messages
0x0040 Show mode pointer of the chip register window
0x0080 Show selection timeouts
0x0100 Show FIFO usage messages
0x0200 Show Queue Full status
0x0400 Show SCB queue status
0x0800 Show inbound packet information
0x1000 Show S/G list information
0x2000 Enable extra diagnostic code in the firmware
The AHD_REG_PRETTY_PRINT option compiles in support for human-readable
bit definitions for each register that is printed by the debugging code.
However, it also bloats the compiled size of the driver by approximately
Individual controllers may be configured to operate in the target role
through the AHD_TMODE_ENABLE configuration option. The value assigned to
this option should be a bitmap of all units where target mode is desired.
For example, a value of 0x25 would enable target mode on units 0, 2, and
5. Note that target mode is only supported for ultra160 speeds and
Per target configuration performed in the SCSI-Select menu, accessible at
boot, is honored by this driver. This includes synchronous/asynchronous
transfers, maximum synchronous negotiation rate, wide transfers, discon-
nection, and the host adapter's SCSI ID.
The ahd driver supports the following:
o Adaptec AIC7901 host adapter chip
o Adaptec AIC7901A host adapter chip
o Adaptec AIC7902 host adapter chip
o Adaptec 29320 host adapter
o Adaptec 39320 host adapter
o Many motherboards with on-board SCSI support
The current generation of 79xx chips do not support target mode in
Ultra320 mode. Target mode in general has not been well tested in this
ahc(4), cd(4), da(4), sa(4), scsi(4)
The ahd driver, the AIC7xxx sequencer-code assembler, and the firmware
running on the aic79xx chips was written by Justin T. Gibbs. This manual
page is based on the ahc(4) manual page.
The ahd driver first appeared in FreeBSD 4.7.
BSD July 4, 2004 BSD