RSH(1) BSD Reference Manual RSH(1)
rsh - remote shell
rsh [-Kdnx] [-k realm] [-l username] host
rsh [-Kdnx] [-k realm] username@host [command]
Rsh executes command on host.
Rsh copies its standard input to the remote command, the standard output
of the remote command to its standard output, and the standard error of
the remote command to its standard error. Interrupt, quit and terminate
signals are propagated to the remote command; rsh normally terminates
when the remote command does. The options are as follows:
-K The -K option turns off all Kerberos authentication.
-d The -d option turns on socket debugging (using setsockopt(2)) on
the TCP sockets used for communication with the remote host.
-k The -k option causes rsh to obtain tickets for the remote host in
realm instead of the remote host's realm as determined by
-l By default, the remote username is the same as the local username.
The -l option or the username@host format allow the remote name to
be specified. Kerberos authentication is used, and authorization
is determined as in rlogin(1).
-n The -n option redirects input from the special device /dev/null
(see the BUGS section of this manual page).
-x The -x option turns on DES encryption for all data exchange. This
may introduce a significant delay in response time.
If no command is specified, you will be logged in on the remote host us-
Shell metacharacters which are not quoted are interpreted on local ma-
chine, while quoted metacharacters are interpreted on the remote machine.
For example, the command
rsh otherhost cat remotefile >> localfile
appends the remote file remotefile to the local file localfile, while
rsh otherhost cat remotefile ">>" other_remotefile
appends remotefile to other_remotefile.
rlogin(1), kerberos(3), krb_sendauth(3), krb_realmofhost(3)
The rsh command appeared in 4.2BSD.
If you are using csh(1) and put a rsh in the background without redirect-
ing its input away from the terminal, it will block even if no reads are
posted by the remote command. If no input is desired you should redirect
the input of rsh to /dev/null using the -n option.
You cannot run an interactive command (like rogue(6) or vi(1)) using
rsh; use rlogin(1) instead.
Stop signals stop the local rsh process only; this is arguably wrong, but
currently hard to fix for reasons too complicated to explain here.
4.2 Berkeley Distribution April 29, 1995 2